20050123-170656
Boards wired up and ready to be assembled onto mounting plate. Left board is GPS module, right board the PocketTrack. Carefully drawn schmatics on paper underneath are for regulator circuit and overall wiring
Viewed: 923 times.
|
20050123-170733
Mounting plate to go into bottom of case. Metalwork isn't my strong suit...
Viewed: 413 times.
|
20050123-202905
Initial checkout of regulator circuit with PocketTrack - note dummy load on transmitter output. Palm V is running the PocketTrack config software
Viewed: 337 times.
|
20050130-183410
Case has been drilled and cable glands (waterproof) have been fitted, ready to wire up. Nearest switch will be Power, one next to it selects programming mode for serial interface into PocketTrack
Viewed: 359 times.
|
20050130-194342
Quick checkout on bike suggests all well - Red LED indicates transmit, Green LED status (constant on means valid GPS position)
Viewed: 373 times.
|
20050130-195351
For trials this week still using external battery. Bit of Cat5 will supply power and allow status LEDs to be seen, albiet only in the pannier with the battery. Intent is to have LEDs visible while riding on final setup
Viewed: 359 times.
|
